Paver Restoration Process - (Cleaning, Re-sand & Seal)

Tip Top Soft Washing will restore the beauty of your pavers!!!

Phase 1:

The most important part is the cleaning of all Pavers. Tip Top has all the proper equipment to clean the pavers with Hot Water properly. Every inch of the patio is cleaned the same way using a high alkaline cleaning. Not only do we clean the organic staining, but rust stains and any other stain is removed.

We remove at least a half inch of old polymeric sand. After all surfaces are cleaned of sand, dirt, staining than we move onto phase 2.

Phase 2:

After 12-24 hours of drying, we return to the project. We begin by cleaning any bird dropping or debris that might be on the surface. After the surface is cleaned of all debris, we start the re-sanding process. After all areas are re-sanded (with the color of the owner’s choice), we start to seal the surface right away.

Phase 3:

The final step is applying the sealer. (THE HOMEOWNER CHOOSES WHICH SEALER)

After applying the jointed sand, we use compactor to assure the sand get in every joint leaving no air pockets. Next, we use a blower on idle to remove any aggregate that may be on top of the pavers. This is important because the seal will not penetrate the pavers with sand on Top.

To finish up, we apply the sealer to the entire surface. It will take 72 Hours to fully cure.


Restore Your Paver / Brick or Natural Stone walkway or patio today by Calling Tip Top Soft Washing and having it Cleaned - Re-sanded & Sealed

Flagstone Patio - Natural stone sealer